Abstract

A thorough and general geometrical optics analysis of a slab-shaped laser gain medium is presented. The length and thickness ratio is critical if one is to achieve the maximum utilization of absorbed pump power by the laser light in such a medium; e.g., the fill factor inside the slab is to be maximized. We point out that the conditions for a fill factor equal to 1, laser light entering and exiting parallel to the length of the slab, and Brewster angle incidence on the entrance and exit faces cannot all be satisfied at the same time. Deformed slabs are also studied. Deformation along the width direction of the largest surfaces is shown to significantly reduce the fill factor that is possible.

© 2007 Optical Society of America

Optical distortions in end-pumped zigzag slab lasers

Bing Tang, Tangjian Zhou, Dan Wang, and Mi Li
Appl. Opt. 54(10) 2693-2702 (2015)

Fluorescence losses from Yb:YAG slab lasers

Ying Chen, Alexandra Rapaport, Te-yuan Chung, Bin Chen, and Michael Bass
Appl. Opt. 42(36) 7157-7162 (2003)

Thermally induced birefringence in Nd:YAG slab lasers

Martin Ostermeyer, Damien Mudge, Peter J. Veitch, and Jesper Munch
Appl. Opt. 45(21) 5368-5376 (2006)

Automatic low-order aberration correction based on geometrical optics for slab lasers

Xin Yu, Lizhi Dong, Boheng Lai, Ping Yang, Yong Liu, Qingfeng Kong, Kangjian Yang, Guomao Tang, and Bing Xu
Appl. Opt. 56(6) 1730-1739 (2017)

Zigzag slabs for solid-state laser amplifiers: batch fabrication and parasitic oscillation suppression

Arun Kumar Sridharan, Shailendhar Saraf, Supriyo Sinha, and Robert L. Byer
Appl. Opt. 45(14) 3340-3351 (2006)