Tolerance Assignment for Minimizing Manufacturing Cost

Michael Kehoe

doi:10.1364/IODC.2010.ITuF5

International Optical Design Conference and Optical Fabrication and Testing
OSA Technical Digest (CD) (Optica Publishing Group, 2010),
paper ITuF5
•https://doi.org/10.1364/IODC.2010.ITuF5

Tolerance Assignment for Minimizing Manufacturing Cost

Michael Kehoe

International Optical Design Conference 2010

Jackson Hole, Wyoming United States
13–17 June 2010
ISBN: 978-1-55752-893-3

From the session
Manufacturing Considerations for Optical Design Producibility and Tolerance Desensitization (ITuF)

Not Accessible

Your library or personal account may give you access

Get PDF
Email
Share
Get Citation
Copy Citation Text
M. Kehoe, "Tolerance Assignment for Minimizing Manufacturing Cost," in International Optical Design Conference and Optical Fabrication and Testing , OSA Technical Digest (CD) (Optica Publishing Group, 2010), paper ITuF5.

Export Citation
- BibTex
- Endnote (RIS)
- HTML
- Plain Text
Citation alert
Save article

Abstract

An automated procedure for tolerance assignment is described. Tolerances are assigned so as to minimize manufacturing cost, subject to a constraint on minimum acceptable lens performance. A simulation evaluates the cost-effectiveness of the program.

PDF Article

More Like This

The Effect of Selective Assembly on Tolerance Desensitization

Max C. Funck and Peter Loosen
ITuF3 International Optical Design Conference (IODC) 2010

Maximizing the Efficiency Cost Ratio in a CPV System via a Tolerant Optical Design

Juan C. Miñano, Pablo Benítez, Pablo Zamora, Rubén Mohedano, Aleksandra Cvetkovic, Marina Buljan, Julio Chaves, and Roberto Alvarez
SMA2 Optics for Solar Energy (SOLED) 2010

Lens Solutions Which Increase Manufacturing Yield

Stan Szapiel and Catherine Greenhalgh
ITuF2 International Optical Design Conference (IODC) 2010

Previous Article Next Article