Expand this Topic clickable element to expand a topic
Skip to content
Optica Publishing Group
  • Optical Fiber Communications Conference
  • OSA Trends in Optics and Photonics (Optica Publishing Group, 2002),
  • paper ThGG4

The contamination of fiber optics connectors and their effect on optical performance

Not Accessible

Your library or personal account may give you access

Abstract

Cleanliness of optical connectors is considered as one of the basic requirements for successful operation of photonic networks. It is common practice to clean connectors before assembly, test and use, since contamination of optical surfaces degrades device performance and causes data errors. A minimum level of cleanliness for single mode optical connector and jumper assemblies has been defined in the Telcordia Technologies Generic Requirements.1 Other leading optoelec-tronics industry manufacturers have provided specifications and important guidelines for cleanliness, notably those from Lucent Technologies and Agilent Technologies.2,3 Tests for assessing the performance of connector assemblies under severe dust conditions is part of the Materials and Environmental section described in.1 The results of such contamination tests have been discussed by Madge and Wisenden.4 It should be noted that the end-face of the connector needs to be extremely clean to maintain reflectances of better than –60 dB.5 It has been shown that scratches to the end-face of the connector resulted in higher reflectance.6 In this investigation our primary concern was the sources of contamination, the mechanism of contaminant transfer onto the critical optical surfaces, as well as influence of contamination/scratches on system performance (BER test). Some practical recommendations to eliminate the need for cleaning and inspection of incoming component optical surfaces have been included.

© 2002 Optical Society of America

PDF Article
More Like This
Reflectance performance of physical-contact single-mode-optical-fiber connectors

V. Shah and W. C. Young
ThA5 Optical Fiber Communication Conference (OFC) 1993

Development of Cleanliness Specifications for Single-Mode Connectors with 1.25 and 2.5 mm Ferrules

Tatiana Berdinskikh, Andrea Ho, Jose Garcia, Carla Gleason, Sun-Yuan Huang, Joyce Kilmer, Steve Lytle, Tom Mitcheltree, Brian J. Roche, Heather Tkalec, Douglas H. Wilson, and Frank (Yi) Zhang
JThB85 National Fiber Optic Engineers Conference (NFOEC) 2006

The Non-Contact Connector: A New Category of Optical Fiber Connector

Benjamin Jian
W2A.1 Optical Fiber Communication Conference (OFC) 2015

Select as filters


Select Topics Cancel
© Copyright 2024 | Optica Publishing Group. All Rights Reserved