Abstract
A uniform plano–convex spherical microlens array with a long focal length was fabricated by combining the micromilling and injection molding processes in this work. This paper presents a quantitative study of the injection molding process parameters on the uniformity of the height of the microlenses. The variation of the injection process parameters, i.e., barrel temperature, mold temperature, injection speed, and packing pressure, was found to have a significant effect on the uniformity of the height of the microlenses, especially the barrel temperature. The filling-to-packing switchover point is also critical to the uniformity of the height of the microlenses. The optimal uniformity was achieved when the polymer melts completely filled the mold cavity, or even a little excessively filled the cavity, during the filling stage. In addition, due to the filling resistance, the practical filling-to-packing switchover point can vary with the change of the filling processing conditions and lead to a non-negligible effect on the uniformity of the height of the microlenses. Furthermore, the effect of injection speed on the uniformity of the height of the microlenses was analyzed in detail. The results indicated that the effect of injection speed on the uniformity of the height of the microlenses is mainly attributed to the two functions of injection speed: transferring the filling-to-packing switchover point and affecting the distribution of residual flow stress in the polymer melt.
© 2014 Optical Society of America
Full Article | PDF ArticleMore Like This
Hsin-Chung Cheng, Chiung-Fang Huang, Yi Lin, and Yung-Kang Shen
Opt. Express 18(26) 26887-26904 (2010)
Liang-Ting Jiang, Tzu-Chien Huang, Chien-Ren Chiu, Chih-Yuan Chang, and Sen-Yeu Yang
Opt. Express 15(19) 12088-12094 (2007)
Lin Zhang, Wenchen Zhou, Neil J. Naples, and Allen Y. Yi
Appl. Opt. 57(13) 3598-3605 (2018)