Design and fabrication of an optical interleaver with cascaded multimode interference couplers
Applied Optics, Vol. 46, Issue 31, pp. 7587-7589 (2007)
http://dx.doi.org/10.1364/AO.46.007587
Enhanced HTML 
Acrobat PDF (372 KB)
Abstract
A lattice-form optical interleaver was designed and fabricated with a silicon-based silica waveguide. Cascaded multimode interference couplers were first employed in the lattice circuit and helped to relax the fabrication tolerance. The device shows good performance, the insertion loss is less than
© 2007 Optical Society of America
OCIS Codes
(130.0130) Integrated optics : Integrated optics
(130.1750) Integrated optics : Components
(130.3120) Integrated optics : Integrated optics devices
ToC Category:
Integrated Optics
History
Original Manuscript: June 12, 2007
Manuscript Accepted: September 5, 2007
Published: October 22, 2007
Citation
Zhujun Wan, Yaming Wu, Jing Yuan, and Fengguang Luo, "Design and fabrication of an optical interleaver with cascaded multimode interference couplers," Appl. Opt. 46, 7587-7589 (2007)
http://www.opticsinfobase.org/ao/abstract.cfm?URI=ao-46-31-7587
You do not have subscription access to this journal. Citation lists with outbound citation links are available to subscribers only. You may subscribe either as an OSA member, or as an authorized user of your institution.
Contact your librarian or system administrator
or
Log in to access OSA Member Subscription
You do not have subscription access to this journal. Cited by links are available to subscribers only. You may subscribe either as an OSA member, or as an authorized user of your institution.
Contact your librarian or system administrator
or
Log in to access OSA Member Subscription
You do not have subscription access to this journal. Figure files are available to subscribers only. You may subscribe either as an OSA member, or as an authorized user of your institution.
Contact your librarian or system administrator
or
Log in to access OSA Member Subscription
You do not have subscription access to this journal. Article level metrics are available to subscribers only. You may subscribe either as an OSA member, or as an authorized user of your institution.
Contact your librarian or system administrator
or
Log in to access OSA Member Subscription
Related Journal Articles 
- Integrated Optical Polarization Splitter Based on Photobleaching-Induced Birefringence in Azo Dye Polymers (AO)
- Hybrid integration of conventional waveguide and photonic crystal structures (OE)
- Small-area bends and beamsplitters for lowindex-contrast waveguides (OE)
- New ring resonator configuration using hybrid photonic crystal and conventional waveguide structures (OE)
- Three-Dimensional Analysis of a Hybrid Photonic Crystal-Conventional Waveguide 90° Bend (AO)
Related Conference Papers
- Using Evolutionary Algorithms for Designing Photonic Crystals
- Individual Control of Multiple AWGs on a Monolithic Chip Using Integrated Thin Film Heaters and Sensors
- Very high order integrated optical filters
- Integrated thin film heater and sensor with arrayed waveguide gratings
- Monolithic Silicon Coherent Receiver
- Monolithic Silicon Coherent Receiver
« Previous Article | Next Article »
OSA is a member of 