|
Optimized half-wave voltage and insertion loss in a strip-loaded waveguide electro-optic polymer modulator |
Applied Optics, Vol. 51, Issue 15, pp. 2917-2924 (2012)
http://dx.doi.org/10.1364/AO.51.002917
Enhanced HTML 
Acrobat PDF (759 KB)
Abstract
A strip-loaded waveguide, electro-optic modulator was designed and analyzed in terms of single mode conditions, optical loss due to the metal electrodes, modulation efficiency, and mode size. Two designs were compared: Design 1 optimized the half-wave voltage (
© 2012 Optical Society of America
OCIS Codes
(230.2090) Optical devices : Electro-optical devices
(230.7370) Optical devices : Waveguides
(250.5460) Optoelectronics : Polymer waveguides
(250.7360) Optoelectronics : Waveguide modulators
ToC Category:
Optical Devices
History
Original Manuscript: January 20, 2012
Revised Manuscript: March 9, 2012
Manuscript Accepted: March 11, 2012
Published: May 16, 2012
Citation
Antonio A. Davis, Perry P. Yaney, and James G. Grote, "Optimized half-wave voltage and insertion loss in a strip-loaded waveguide electro-optic polymer modulator," Appl. Opt. 51, 2917-2924 (2012)
http://www.opticsinfobase.org/ao/abstract.cfm?URI=ao-51-15-2917
You do not have subscription access to this journal. Citation lists with outbound citation links are available to subscribers only. You may subscribe either as an OSA member, or as an authorized user of your institution.
Contact your librarian or system administrator
or
Log in to access OSA Member Subscription
You do not have subscription access to this journal. Cited by links are available to subscribers only. You may subscribe either as an OSA member, or as an authorized user of your institution.
Contact your librarian or system administrator
or
Log in to access OSA Member Subscription
You do not have subscription access to this journal. Figure files are available to subscribers only. You may subscribe either as an OSA member, or as an authorized user of your institution.
Contact your librarian or system administrator
or
Log in to access OSA Member Subscription
You do not have subscription access to this journal. Article level metrics are available to subscribers only. You may subscribe either as an OSA member, or as an authorized user of your institution.
Contact your librarian or system administrator
or
Log in to access OSA Member Subscription
Related Journal Articles 
- Polymer in-line fiber modulators for broadband radio-frequency optical links (JOSAB)
- Fabrication and characterization of single-mode electro-optic polymer optical fiber (OL)
- Electrooptic modulation up to 40 GHz in a barium titanate thin film waveguide modulator (OE)
- BaTiO3 thin-film waveguide modulator with a low voltage-length product at near-infrared wavelengths of 0.98 and 1.55 µm (OL)
- Field induced dynamic waveguides based on potassium tantalate niobate crystals (OE)
Related Conference Papers
- Si3N4 strip loaded waveguide electro-optic phase modulator in epitaxial BaTiO3 thin film
- Photonic-Crystal-Waveguide-Based Silicon Mach-Zehnder Modulators
- Velocity Matching in BaTiO3 Thin Film Electrooptic Waveguide Modulators
- Fast, reduced order full-wave FEM analysis of broadband traveling-wave electrooptical modulators
- Accurate and efficient numerical quasi-TEM modeling of coplanar waveguides for high-speed electro-optic modulators
« Previous Article | Next Article »
OSA is a member of 