Abstract

Laser diffraction particle size measurements are used to study aerodynamic mass transport losses of a finely ground aqueous coal slurry aerosol in the spray chamber of a conventional atomic absorption spectrometer. A swing mill used to grind the coal produces many particles small enough to transport efficiently in the aerosol stream, but some are too large and can settle out in the spray chamber. This effect is reduced but not eliminated if one passes the grindings through a 325-mesh sieve prior to weighing and direct analysis. In spite of the partial "leveling effect" produced by the sieve, the residual mass transport loss in the spray chamber for direct coal slurry analysis by flame AA is about 51% (relative to aqueous standard transport). This accounts for part of the five-fold decrease in absorbance previously reported for finely ground coal slurries as compared with aqueous solutions. The remainder of the decrease is due to incomplete combustion and vaporization of coal particles in the nitrous-oxide/acetylene flame.

Three-dimensional combined pyrometric sizing and velocimetry of combusting coal particles. I. Velocimetry

Pal Toth, Teri Draper, Arpad B. Palotas, Terry A. Ring, and Eric G. Eddings
Appl. Opt. 54(13) 4049-4060 (2015)

Particle size and surfactant effects on chemical mechanical polishing of glass using silica-based slurry

Zefang Zhang, Weili Liu, and Zhitang Song
Appl. Opt. 49(28) 5480-5485 (2010)

Slurry particle size evolution during the polishing of optical glass

M. J. Cumbo, D. Fairhurst, S. D. Jacobs, and B. E. Puchebner
Appl. Opt. 34(19) 3743-3755 (1995)

Optical particle sizing for in situ measurements Part 2

Don Holve and Sidney A. Self
Appl. Opt. 18(10) 1646-1652 (1979)

Two-wavelength laser transmissometer for measurements of the mean size and concentration of coal ash droplets in combustion flows

P. C. Ariessohn, S. A. Self, and R. H. Eustis
Appl. Opt. 19(22) 3775-3781 (1980)