Expand this Topic clickable element to expand a topic
Skip to content
Optica Publishing Group
  • Applied Spectroscopy
  • Vol. 54,
  • Issue 6,
  • pp. 773-782
  • (2000)

Modeling and Measuring the Effect of Refraction on the Depth Resolution of Confocal Raman Microscopy

Not Accessible

Your library or personal account may give you access

Abstract

A simple ray-tracing analysis has been used to predict the effect of refraction at the sample/air interface, on the depth resolution of confocal Raman microscopy. This analysis applies to the 'z-scanning', or 'optical sectioning', approach to obtaining depth profiles, where the laser beam is incident normal to the sample surface, and spectra are recorded sequentially as the focus is moved deeper into the material. It is shown that when a 'dry' metallurgical objective (the most common configuration for commercial Raman microscopes) is used, both the position and the depth of focus increase dramatically as the beam is focused deeper into the sample. It quickly becomes impossible to obtain 'pure' spectra of thin layers that are buried more than a few micrometers below the air interface. Equations are presented which model the intensity response expected when focusing through a coating into a substrate. The model requires knowledge of the sample refractive index, the numerical aperture, and the laser beam intensity distribution at the limiting aperture, of the objective. Given these values, one can predict the substrate Raman intensity as a function of the nominal focal point within the sample. For a 36μm coating on a thick substrate, we predict that even for a perfectly sharp interface (1μm), substrate bands rise slowly (over an apparent distance of 10μm or more), and are strong when the focus is apparently only ~18μm below the air/coating interface. This prediction was confirmed through experimental observation. The model was also used to analyze literature data that had been interpreted previously as showing interfacial diffusion in polymer laminates. The model correctly reproduced the main features of the observed data without invoking interfacial penetration - the optical aberrations alone accounted for almost all the observed broadening and the fact that the apparent thickness of the buried layer is also distorted. It was concluded that, with the use of this illumination geometry, it is very difficult to detect or quantify interfacial broadening unless it occurs on a very large scale indeed (tens of micrometers). It is concluded that 'optical sectioning' cannot be recommended for quantitative depth profiling at significant depths using metallurgical objectives. The optimum practical solution is to cut a cross section and map laterally across the sample, thereby utilizing and maintaining the excellent (lateral) resolution of the Raman microprobe. An alternative solution is to use an immersion objective to minimize refraction at the sample surface.

PDF Article
More Like This
Depth profiles in confocal optical microscopy: a simulation approach based on the second Rayleigh-Sommerfeld diffraction integral

Rosario Esposito, Giuseppe Scherillo, Marianna Pannico, Pellegrino Musto, Sergio De Nicola, and Giuseppe Mensitieri
Opt. Express 24(12) 12565-12576 (2016)

Confocal microscopy based on dual blur depth measurement

Tao Yuan, Wei Jiang, Yiqing Ye, Yongjie Hai, and Dingrong Yi
J. Opt. Soc. Am. A 40(11) 2002-2007 (2023)

Correction of diffraction effects in confocal Raman microspectroscopy

A. Gallardo, R. Navarro, H. Reinecke, and S. Spells
Opt. Express 14(19) 8706-8715 (2006)

Cited By

You do not have subscription access to this journal. Cited by links are available to subscribers only. You may subscribe either as an Optica member, or as an authorized user of your institution.

Contact your librarian or system administrator
or
Login to access Optica Member Subscription

Select as filters


Select Topics Cancel
© Copyright 2024 | Optica Publishing Group. All Rights Reserved