This paper discusses a method of reducing the polarization dependence of gain (PDG) of a distributed Raman amplifier. Reducing its PDG is important for a Raman amplifier because it is higher than that of an erbium-doped fiber amplifier and can degrade transmission performance. Raman PDG is determined primarily by two factors, namely 1) polarization-mode dispersion (PMD) of the transmission fiber and 2) degree of polarization (DOP) of the pump source. The authors propose a simple analytical model to show the required pump light DOP for a given transmission fiber's PMD and the allowable PDG. For instance, a low pump DOP of 5% produces a low PDG of 0.2 dB under typical fiber PMD conditions, in which the analytical model agrees well with experiment. Subsequently, to achieve the required DOP, the pump source configuration is investigated in detail. The authors used one length of polarization-maintaining fiber (PMF) as an efficient pump depolarizer and evaluated its performance for various pump light spectra. It has been shown that the DOP following the depolarizer is determined simply by Fourier transformation of the pump light spectrum. The analysis in this paper has led to the important result that a Fabry–Pérot laser diode pump with a short piece of PMF is effective in achieving a low pump DOP due to its multimode spectrum when the length of the PMF is properly adjusted for the longitudinal-mode spacing frequency. It has been verified that a Raman amplifier's PDG can be reduced by the proposed efficient depolarizer sufficiently for a PDG-reduced Raman amplifier repeater to be applicable to long-haul transmission systems.
© 2006 IEEE
Toshiyuki Tokura, Taichi Kogure, Takashi Sugihara, Katsuhiro Shimizu, Takashi Mizuochi, and Kuniaki Motoshima, "Efficient Pump Depolarizer Analysis for Distributed Raman Amplifier With Low Polarization Dependence of Gain," J. Lightwave Technol. 24, 3889-3896 (2006)