Abstract

Multimode polymer waveguides are an attractive transmission medium for board-level optical links as they provide high bandwidth, relaxed alignment tolerances, and can be directly integrated onto conventional printed circuit boards. However, the performance of multimode waveguide components depends on the launch conditions at the component input, complicating their use in topologies that require the concatenation of multiple multimode components. This paper presents key polymer components for a multichannel optical bus and reports their performance under different launch conditions, enabling useful rules that can be used to design complex interconnection topologies to be derived. The components studied are multimode signal splitters and combiners, 90°-crossings, S-bends, and 90°-bends. By varying the width of the splitter arms, a splitting ratio between 1% and 95% is achieved from the 1 × 2 splitters, while low-loss signal combining is demonstrated with the waveguide combiners. It is shown that a 3 dB improvement in the combiner excess loss can be achieved by increasing the bus width by 50 μm. The worst-case insertion loss of 50 × 100 μm waveguide crossings is measured to be 0.1 dB/crossing. An empirical method is proposed and used to estimate the insertion losses of on-board optical paths of a polymeric four-channel optical bus module. Good agreement is achieved between the predicted and measured values. Although the components and empirical method have been tailored for use in a multichannel optical bus architecture, they can be used for any on-board optical interconnection topology.

© 2013 IEEE

Regenerative polymeric bus architecture for board-level optical interconnects

N. Bamiedakis, A. Hashim, R. V. Penty, and I. H. White
Opt. Express 20(11) 11625-11636 (2012)

Transition, radiation and propagation loss in polymer multimode waveguide bends

Ioannis Papakonstantinou, Kai Wang, David R. Selviah, and F. Aníbal Fernández
Opt. Express 15(2) 669-679 (2007)

Optical printed circuit boards with multimode polymer waveguides and pluggable connectors for high-speed optical interconnects

Ying Shi, Xu Liu, Lin Ma, Marika Immonen, Longxiu Zhu, and Zuyuan He
Opt. Express 31(17) 27776-27786 (2023)

Directly inscribed multimode polymer waveguide and 3D device for high-speed and high-density optical interconnects

Xiao Xu, Lin Ma, Ying Shi, Takaaki Ishigure, and Zuyuan He
Opt. Express 27(16) 22419-22428 (2019)

Investigation on mode dispersion and lamination stability of multimode polymer waveguides for an optical backplane

Xiao Xu, Xu Liu, Marika Immonen, Lin Ma, and Zuyuan He
Opt. Express 30(22) 40505-40514 (2022)