## Thermal tuning of optical cavities for parametric instability control

JOSA B, Vol. 24, Issue 6, pp. 1336-1343 (2007)

http://dx.doi.org/10.1364/JOSAB.24.001336

Enhanced HTML Acrobat PDF (575 KB)

### Abstract

Thermal tuning of optical Fabry–Perot cavities has been proposed to reduce the parametric gain of high-frequency parametric instabilities in gravitational wave detectors. We investigate the performance achievable for such tuning obtained by thermal actuation of the mirrors (also called test masses) of the arm cavities. We show that for test mass dimensions used in advanced detectors, when circularly symmetric heating is applied to the rear side of the mirror, the steady-state tuning performance is almost independent of the heating pattern and depends only on the heating power. We derived the optimal time-dependent heating required to achieve the fastest possible actuation in sapphire and fused-silica substrates. Our simulations show that sapphire mechanical deformation response to heating is 15 times faster than that of fused silica, although sapphire requires three times more heating power to obtain the same radius of curvature change.

© 2007 Optical Society of America

**OCIS Codes**

(120.6810) Instrumentation, measurement, and metrology : Thermal effects

(160.4670) Materials : Optical materials

**ToC Category:**

Optical Devices

**History**

Original Manuscript: September 22, 2006

Revised Manuscript: February 2, 2007

Manuscript Accepted: February 19, 2007

Published: May 17, 2007

**Citation**

Jérôme Degallaix, Chunnong Zhao, Li Ju, and David Blair, "Thermal tuning of optical cavities for parametric instability control," J. Opt. Soc. Am. B **24**, 1336-1343 (2007)

http://www.opticsinfobase.org/josab/abstract.cfm?URI=josab-24-6-1336

Sort: Year | Journal | Reset

### References

- V. B. Braginsky, S. E. Strigin, and S. P. Vyatchanin, "Analysis of parametric oscillatory instability in power recycled LIGO interferometer," Phys. Lett. A 305, 111-124 (2002). [CrossRef]
- P. R. Saulson, Fundamentals of Interferometric Gravitational Wave Detectors (World Scientific, 1984).
- G. Heinzel, K. Strain, J. Mizuno, K. Skeldon, B. Willke, W. Winkler, R. Schilling, A. Rudiger, and K. Danzmann, "Experimental demonstration of a suspended dual recycling interferometer for gravitational wave detection," Phys. Rev. Lett. 81, 5493-5496 (1998). [CrossRef]
- D. Shoemaker, "Advanced LIGO," in Fifth Edoardo Amaldi Conference on Gravitational Waves, Tirrenia, Italy, July 6-11, 2003.
- V. B. Braginsky, S. E. Strigin, and S. P. Vyatchanin, "Parametric oscillatory instability in Fabry-Perot interferometer," Phys. Lett. A 287, 331-338 (2001). [CrossRef]
- See http://www.ligo.caltech.edu/advLIGO/.
- V. B. Braginsky, A. Gurkovsky, S. E. Strigin, and S. P. Vyatchaninl, "Analysis of parametric oscillatory instability in signal recycled LIGO interferometer," submitted to the LIGO Scientific Collaboration Review Comittee.
- C. Zhao, L. Ju, J. Degallaix, S. Gras, and D. G. Blair, "Parametric instabilities and their control in advanced interferometer gravitational-wave detectors," Phys. Rev. Lett. 94, 121102 (2005). [CrossRef] [PubMed]
- J. M. Hill and J. N. Dewynne, Heat Conduction (Blackwell Scientific, 1987), section entitled "Radial flow in solid circular cylinders and sphere."
- A. E. Siegman, Lasers (University Science, 1986).
- For this calculation we used the software FINESSE with the specification of Advanced LIGO with a Schnupp asymmetry of 40 cm.
- H. Lück, A. Freise, S. Goler, K. Kawabe, and K. Danzmann, "Thermal correction of the radii of curvature of mirrors for GEO 600," Class. Quantum Grav. 21, S985-S989 (2004). [CrossRef]
- R. Lawrence, "Active wavefront correction in laser interferometric gravitational wave detectors," Ph.D thesis (MIT, 2003).
- S. Ballmer, V. Frolov, R. Lawrence, W. Kells, G. Moreno, K. Mason, D. Ottaway, M. Smith, C. Vorvick, P. Willems, and M. Zucker, "Thermal compensation description," LIGO Internal Document T050064-00-R (LIGO, 2005).
- R. Savage, M. Rakhmanov, K. Kawabe, and J. Betswieser, "Summary of recent measurements of g factor changes induced by thermal loading in the H1 interferometer," LIGO Internal Document G050111-00-W (LIGO, 2005).
- H. Lück, S. Hild, S. Goler, and the GEO 600 Team, "Thermal compensation of the radius of curvature of GEO600 mirrors," in Fifth Edoardo Amaldi Conference on Gravitational Waves, Tirrenia, Italy, July 6-11, 2003.
- The temperature is a linear function of the heating sources only for a small increase of temperature (less than 10 K). In this condition of a small increase, the heating loss due to radiation can be approximated as proportional to the temperature.
- L. Ju, C. Zhao, S. Gras, J. Degallaix, D. Blair, J. Munch, and D. H. Reitze, "Comparison of parametric instabilities for different test mass materials in advanced gravitational wave interferometers," Phys. Lett. A 355, 419-426 (2006). [CrossRef]
- J. Degallaix, "Thermal lensing time constant for sapphire and fused silica substrates," Australian International Gravitation Observatory, Military Road, Gingin, Australia; internal presentation, available on demand, 2004.
- R. Savage, M. Rakhmanov, K. Kawabe, and S. Waldman, "Measurement of thermally induced test mass surface curvature changes in a LIGO 4-km interferometer," LIGO Internal Document G050362-00-W (LIGO, 2005).
- R. Savage, M. Rakhmanov, K. Kawabe, and J. Betswieser, "Summary of H1 g factor measurements," LIGO Internal Document G050030-00-W (LIGO, 2005).
- S. Gras, C. Zhao, L. Ju, and D. G. Blair, "Preliminary investigation on a passive method for parametric instability control in advanced gravitational wave detectors," J. Phys.: Conf. Ser. 32, 251-258 (2006). [CrossRef]
- D. Marquardt, "An algorithm for least-squares estimation of nonlinear parameters," SIAM J. Appl. Math. 11, 431-441 (1963). [CrossRef]

## Cited By |
Alert me when this paper is cited |

OSA is able to provide readers links to articles that cite this paper by participating in CrossRef's Cited-By Linking service. CrossRef includes content from more than 3000 publishers and societies. In addition to listing OSA journal articles that cite this paper, citing articles from other participating publishers will also be listed.

« Previous Article | Next Article »

OSA is a member of CrossRef.