Grinding aspheric surfaces of optical workpieces with a full-size tool
Journal of Optical Technology, Vol. 79, Issue 3, pp. 157-159 (2012)
http://dx.doi.org/10.1364/JOT.79.000157
Acrobat PDF (85 KB)
Abstract
This article briefly describes the results of the development and use at NPO GIPO of a full-size tool with an aspheric working surface for grinding. Aspherization is carried out with free abrasive on domestically produced Planeta machines, developed in the 1970s–80s by specialists at NPO GIPO and the Minsk Mechanical Factory and fabricated in Smorgon’ (Belarus).
© 2012 OSA
History
Original Manuscript: May 18, 2011
Published: March 30, 2012
Citation
V. G. Kuks, "Grinding aspheric surfaces of optical workpieces with a full-size tool," J. Opt. Technol. 79, 157-159 (2012)
http://www.opticsinfobase.org/jot/abstract.cfm?URI=jot-79-3-157
You do not have subscription access to this journal. Citation lists with outbound citation links are available to subscribers only. You may subscribe either as an OSA member, or as an authorized user of your institution.
Contact your librarian or system administrator
or
Log in to access OSA Member Subscription
You do not have subscription access to this journal. Cited by links are available to subscribers only. You may subscribe either as an OSA member, or as an authorized user of your institution.
Contact your librarian or system administrator
or
Log in to access OSA Member Subscription
« Previous Article | Next Article »
OSA is a member of 